How To: Enable Creator Mode

It is recommended that customers enable Creator Mode within their Magic Leap device in the event they forget their PIN or for direct access to their device via a computer.

Follow the steps below to set this up properly.

Creator Mode Pre-Requisites

- Ensure you have an active WiFi connection (you can verify by opening Helio and browsing to your favorite website)

- Registered as a developer with your Magic Leap ID

- Accepted the End User License Agreement (EULA) on creator.magicleap.com.

To enable on your device:

  1. Connect a device to your computer over USB.
  2. On the device navigate to Settings > Device > Creator Mode.
  3. Select the following:
    • Enable Creator Mode - Make Creator Mode options available for selection.
    • Allow Untrusted Sources - Install apps signed with a development certificate.
    • Enable MLDB Access - Allow Magic Leap Device Bridge to connect to your device.

      ml1-creator-mode

Once you have completed the above, you should now be able to connect using MLDB to your device.

Was this article helpful?