Once you've prepared your Magic Leap 2 for use, it's time to power on the device and set it up.
Power on your device - press and hold the power button on the Compute
Pack until the LED lights begin to illuminate. Put on the Headset.
After a boot-up animation plays, the Out-of-Box Experience (OOBE, for short) prompt appears. It's time to complete OOBE.
Out of Box Experience
OOBE starts with instructions on pairing the controller.
Pairing and Updating the Controller
Press and hold the Home button on your controller until you hear a tone and see the LED light appear. If the LED light is blue, it isn’t paired. Directly connect the Controller to the Compute Pack using the USB-C to USB-C cable included in the box to fix this.
CAUTION: Don't disconnect the Controller until you’ve fully updated and paired it with your device.
Select Language
After pairing your controller, you're be prompted to select your language. English is selected by default. Only English and Japanese are available currently.
Prescription Inserts
If you have prescription inserts for your device, add them before continuing.
Software License Agreement
Read and accept the Software License agreement. You can also enable the Software License Agreement to be prompted again later.
Enrollment
If you have a QR code to enroll in a device management solution like VMWare WorkplaceONE, select the "Scan QR Code" option to scan the code and enroll your device. Otherwise, you can skip this step.
Wi-Fi
As the final setup step, connect to Wi-Fi. Not an option right now? Press "Skip".
You are now ready to use your device. Refer to our User Guide for more helpful articles.